Diamond wire saw for reinforced concrete's the working principle and operating specifications

Diamond wire saw for reinforced concrete is mainly used for cutting reinforced concrete such as housing construction, bridges, subways, and underwater buildings. In addition, diamond wire saw for reinforced concrete can perform deep cutting, diamond wire saw for reinforced concrete can saw steel, concrete, and other building materials, diamond wire saw for reinforced concrete can perform large-size sawing on pipes and pipelines, and diamond wire saw for reinforced concrete can operate with pulleys in a narrow space. Diamond wire saw for reinforced concrete can be applied to various openings with precise corners. So do you know the working principle and operating specifications of diamond wire saw for reinforced concrete? Here are some answers.

Here is the content list:

• Diamond wire saw for reinforced concrete's the working principle.

• Diamond wire saw for reinforced concrete's operating specifications.

• Diamond wire saw for reinforced concrete 's safe operation specification.

Diamond wire saw for reinforced concrete's the working principle.

Diamond wire saw for reinforced concrete can be driven by a hydraulic motor or an electric motor. Diamond wire saw for reinforced concrete is mainly composed of the main motion system, feed system, diamond bead saw the tensioning device, guiding mechanism, control system, cooling system, and other components. Diamond wire saw for reinforced concrete cutting is usually closed-loop type, relying on the equipment installed on the track to drive at the ideal speed.

Diamond wire saw for reinforced concrete's operating specifications.

First, when using diamond wire saw for reinforced concrete, straighten the rope and twist it according to 1-2 turns/m, which can effectively prevent diamond wire saw for reinforced concrete from eccentric wear. Then connect the wire saw into a closed loop with hydraulic pliers and press buckles. Before cutting, you must distinguish the direction of the use of diamond wire saw for reinforced concrete, and do not rotate and cut in the opposite direction.

Second, try to avoid sharp-angle cutting in diamond wire saw for reinforced concrete to avoid damage to the rope, and add support guide wheels if necessary.

Third, the wear of the guide wheel will reduce the coincidence between diamond wire saw for reinforced concrete and the guide wheel, affect the linear speed of diamond wire saw for reinforced concrete, and then affect the cutting efficiency, and the rubber ring of the guide wheel needs to be replaced in time.

Fourth, when diamond wire saw for reinforced concrete is cutting, it must be cooled, and the amount of water can be adjusted according to the noise during cutting and the turbidity of the cooling water. The amount of cooling water is not as much as possible. Too much cooling water will easily affect the self-sharpening of diamond wire saw for reinforced concrete and cause diamond wire saw for reinforced concrete to slip; too little cooling water will easily cause the beads to heat up and affect the cutting life.

Fifth, pay attention to ensuring the tension of diamond wire saw for reinforced concrete. If the tension is too small, the cutting speed will be slow and it will be easy to get off the rope. If the tension is too large, diamond wire saw for reinforced concrete wears out quickly, and there is a risk of the rope breaking at the connection.

Sixth, when diamond wire saw for reinforced concrete is not in use, the tension should be unloaded and stored in a dry place.

Diamond wire saw for reinforced concrete 's safe operation specification.

First, all diamond wire saw for reinforced concrete equipment should comply with national or related standards. Second, safety isolation facilities and personal protection measures must be provided around the work surface of site diamond wire saw for reinforced concrete before construction can be carried out. Third, when diamond wire saw for reinforced concrete is working, the person must stay 15 meters away from the working surface, and it is strictly forbidden to stay in the tangent area of the diamond wire saw for reinforced concrete running direction. If on-site maintenance is required, the operation must be performed after shutdown. Fourth, during the use of diamond wire saw for reinforced concrete, it is a normal phenomenon that some beads are loose due to wear, impact, etc. After a cutting operation is completed, the product status must be checked, and the loose part of the beads should be cut off, or the product should be stopped.

Our official website is https://www.singoon.com/. If you want to buy diamond wire saw for reinforced concrete, you can contact us on the website.