What are the operating procedures of the diamond segment?

Stone cutting segment machine, also known as stone cutting machine, is a kind of multi-knife and multi-stage stone cutting machine, which is composed of a cutting knife group, stone conveying table, positioning guide plate and frame.

The use of stone cutting segment

Operating procedures for the stone cutting segment

Stone cutting segment operation finishing work

The use of stone cutting segment

Stone cutting segment machine is composed of cutting tool group, stone conveying platform, positioning guide plate and frame. Stone cutting segment machine is made of iron suitable for dry cutting, wet cutting of all kinds of stone, building materials, tiles, granite, marble, cement board, red brick, refractory brick and so on. It is a necessary weapon for home decoration.

Stone cutting segment machine can cut stone at different depths, can process stone less than 1m3, can change waste into treasure, greatly save stone resources, but also conducive to the protection of the environment can be used for various types of stone mechanical cutting, processing efficiency is high, coupled with the effective use of small stone, so that the production cost is lower.

Operating procedures for the stone cutting segment

Before work

1. Put on your work clothes, wear your goggles, and put your hair on a work cap with long hair.

2. The power gate switch, the tightness of the saw blade, the saw blade shield or the safety baffle should be inspected in detail. The operating table must be stable and the night operation should be adequately illuminated.

3. Turn on the main switch, run a few laps without load, and be allowed to start until it is confirmed to be safe.

Working time

1. It is strictly forbidden to wear gloves. If dust will be caused in the course of operation, wear a mask or mask.

2. No attempt shall be made to cut a small piece of work that is not clamped by a saw.

3. This cutting machine is only allowed to cut profiles.

4. No strong cutting saw operation shall be carried out, and the motor should reach full speed before cutting.

Stone cutting segment operation finishing work

1. Turn off the main power supply

2. Clean and tidy up the worktable and site.

Double desktop stone cutting segment machine circumferential spring staggered tooth clearance structure, two thin desktop stone cutting machine set together, each desktop stone cutting segment machine has two circumferential through grooves, on the end face of the desktop stone cutting segment machine equipped with short columns, used to install springs. When assembling, the spring has enough tension to make the left and right sides of the two thin table stone cutting machines close to the left and right sides of the wide table stone cutting machine respectively, in order to eliminate the clearance on the tooth side.

In China, the industrial added value of the light stone cutting machine industry accounts for about 35% of GDP, and the gross national product (GDP) is created by the light stone cutting machine industry. The technical system diagram of an advanced light stone cutting machine composed of a multi-level technical group is put forward by the Institute of Mechanical Science.

In addition, we also provide Dimond Wire Saw, Diamond Saw Blade and other products.